What Hilti 500?

What Hilti 500?

Fifteen years ago, Hilti set legendary standards for designers and contractors with the HIT-RE 500 – the first epoxy injectable mortar for post-installed anchors and rebar fixings. And because our customers needed the same high performance and maximum reliability for cracked concrete, we introduced HIT-RE 500-SD.

What is the shelf life of Hilti epoxy?

Hilti HIT-RE 500 V3 Epoxy Mortar

Anchoring Elements HIT-V threaded rods
Cleaning Procedures Automatic cleaning
Storage and Transportation Temperature Range 5 – 25 Degree C
In-service Temperature Range -40 – 70 Degree C
Shelf Life 12 months from date of manufacture (at 23 DegreeC and 50% relative humidity)

Which is best chemical for Rebaring?

ICFS 350 ml Rebaring Chemical Injection Mortar Adhesive (350 ml)

Brand ICFS
Composition Unsaturated Polyster Resin
Suitable For Concrete, Masonry, Stone, Bricks
Adhesive Type Gel
Used For Anchoring in cracked and non cracked concrete, Chemical Anchor Fixing, Bolt Fixing, Steel Rebar Fixing

What is the new Hilti hit-re 500 V3 injection system?

The new HIT-RE 500 V3 delivers ultimate performance and safety in design while making installation even easier and faster than ever before. Teamed up with SafeSet and PROFIS software, HIT-RE 500 V3 is nothing short of revolutionary. Hilti HIT-RE 500 V3 injection system

Which is the best hit-re 500 V3 epoxy anchor?

Hilti HIT-RE 500 V3 is the only epoxy adhesive anchor that cures below freezing and is rated down to 23 o F. Balance longer work times with shorter cure times. Hilti HIT-RE 500 V3 gives you a 25-minute working time at 72 o with initial cure in four hours and full cure in six hours.

What can hit re 500 V3 be used for?

HIT-RE 500 V3 works for post-installed anchoring in dry, wet and water-filled concrete, even if drilled holes are underwater. It is also approved for use in seismic applications.

How to clean hit-re 500 V3 drilling hole?

HIT-RE 500 V3 adhesive can be installed using two cleaning options: 1. Traditional cleaning methods comprised of steel wire brushes and air nozzles, 2. Self-cleaning methods using the Hilti TE-CD or TE-YD hollow carbide drill bits used in conjunction of a Hilti vacuum cleaner that will remove drilling dust, automatically cleaning the hole.